This shows you the differences between two versions of the page.
Next revision Both sides next revision | |||
2d_stm [2009/11/30 12:24] vroz created |
2d_stm [2009/11/30 12:37] vroz |
||
---|---|---|---|
Line 1: | Line 1: | ||
\\ | \\ | ||
- | === 2D STM === | + | ==== 2D STM ==== |
+ | This scan is tipical STM scan, the output are the xyz files, where the z-value is the tunelling current over the specific xy position. The **ICUTT** value should be set as the 0 in the "options.inp" file. The **XMIN, XMAX** and **YMIN, YMAX** should be set properly. There is necessary to have **XMIN, YMIN** set at the initial point of scan, **XMAX, YMAX** could be zero, the **STM** code fill here the values of the end of unit cell automatically. | ||
+ | \\ | ||
+ | |||
+ | === Output === |