Nanosurf Lab

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

 \\

==== 2D STM ====

This scan is tipical STM scan, the output are the xyz files, where the z-value is the tunelling current over the specific xy position. The **ICUTT** value should be set as the 0 in the "options.inp" file. The **XMIN, XMAX** and **YMIN, YMAX** should be set properly. There is necessary to have **XMIN, YMIN** set at the initial point of scan, **XMAX, YMAX** could be zero, the **STM** code fill here the values of the end of unit cell automatically. 

 \\

=== Output === 

As an output we will obtain several files ("current_sample_deno.out", "current_tip_deno.out" [where "deno" could be replaced by "nden", depending on the setup of denominator /multiple scattering/]). The number of rows depends on the number of scans in each direction and on the number of written cells (the tip is scanning just the basic cell, but if you want to see wider area, you set the number of written neigbour cells in each direction, than the code write out even the copies of original scan shifted on the xy plane).

Nanosurf Lab

User Tools

Site Tools

Page Tools