User Tools

Site Tools


dft_inputs

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
dft_inputs [2016/12/08 09:23]
krejcio
dft_inputs [2017/01/26 14:58]
krejcio
Line 3: Line 3:
 == Fireball == == Fireball ==
  
-fireball.in for creation of an fftpot.xsf file with Hartree potential with using a McWEDA functional should look like:+__fireball.in__ for creation of an __fftpot.xsf__ file with Hartree potential with using a McWEDA functional should look like:
  
   &OPTION   &OPTION
Line 28: Line 28:
   &END   &END
  
-fireball.in file for calculations with XC on a grid computations:​+__fireball.in__ file for calculations with XC on a grid computations:​
  
   &OPTION   &OPTION
Line 62: Line 62:
 [[http://​www.vasp.at/​]] [[http://​www.vasp.at/​]]
  
-LOCPOT ​file containing the Hartree potential is produced during standart VASP run. One just have to care about a dipole correction (if necessary). The LOCPOT ​file has to be convert into an *.xsf file, eg. via [[http://​theory.chm.tu-dresden.de/​~jk/​software.html]]+__LOCPOT__ ​file containing the Hartree potential is produced during standart ​//VASP// run. One just have to care about a dipole correction (if necessary). The __LOCPOT__ ​file has to be convert into an *.xsf file, eg. via [[http://​theory.chm.tu-dresden.de/​~jk/​software.html]]
  
 == FHI-AIMS == == FHI-AIMS ==
Line 69: Line 69:
 [[http://​aimsclub.fhi-berlin.mpg.de/​]] [[http://​aimsclub.fhi-berlin.mpg.de/​]]
  
-Add following sequention into you control.in+Add following sequention into your __control.in__ file:
  
   output cube hartree_potential   output cube hartree_potential
     cube origin lx ly lz     cube origin lx ly lz
  
-where lx, ly & lz are shifting the output cube file so the written grid would be at the beginning of the Cartesian system. PPM can now read geometry from a cube file created by FHI-AIMS and shift it according to the shift of the cube cell; however for good run of the PPM calculation at least lz has to be properly specified. l = length of lattice vector / 2 - 0.05; But proper shift is used only, when the lattice vector follows some Cartesian direction.+where lx, ly & lz are shifting the output cube file so the written grid would be at the beginning of the Cartesian system. PPM can now read geometry from a cube file created by //FHI-AIMS// and shift it according to the shift of the cube cell; however for good run of the PPM calculation at least lz has to be properly specified. l = length of lattice vector / 2 - 0.05; But proper shift is used only, when the lattice vector follows some Cartesian direction.
  
dft_inputs.txt ยท Last modified: 2017/01/26 14:58 (external edit)