This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
fire_bfgs_minimization [2011/08/12 11:41] admin |
fire_bfgs_minimization [2011/08/12 11:42] admin |
||
---|---|---|---|
Line 14: | Line 14: | ||
This routine uses the same input file as Conjiged Gradients (iquench = -4). It does not use all parameters, but they must be there. | This routine uses the same input file as Conjiged Gradients (iquench = -4). It does not use all parameters, but they must be there. | ||
//0.1 ! max displacement// - NOT USED in BFGS | //0.1 ! max displacement// - NOT USED in BFGS | ||
- | // 0.1 ! dummy argume//nt - NOT USED in BFGS | + | // 0.1 ! dummy argume//nt - NOT USED in BFGS |
//0.00000001 ! total energy tolerance// - NOT USED in BFGS | //0.00000001 ! total energy tolerance// - NOT USED in BFGS | ||
0.001 ! fmax - force tolerance - end of minimization if fij<fmax | 0.001 ! fmax - force tolerance - end of minimization if fij<fmax | ||
- | // 10000 ! Max number of opt steps// ** NOT USED IN BFGS** - now the max. number of steps is given by parameter nstepf in firaball.in | + | //10000// ! Max number of opt steps - NOT USED IN BFGS - now the max. number of steps is given by parameter nstepf in firaball.in |
0 !number of restarts in case ftot>fmax (it seems it nave no effect) | 0 !number of restarts in case ftot>fmax (it seems it nave no effect) | ||
0 !if >0 then dt must be defined in fireball.in. Number of FIRE downhill steps after BFGS minimization "fails" | 0 !if >0 then dt must be defined in fireball.in. Number of FIRE downhill steps after BFGS minimization "fails" |