This shows you the differences between two versions of the page.
linear_stm [2009/11/30 11:31] vroz |
linear_stm [2011/02/18 13:13] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ==== The Linear STM ==== | ||
- | The linear scanning gives us the current profile from the A point to the B point at constant height of the tip. To run this kind of scan we need to change some values at the "scan.inp" and "options.inp" files. | ||
- | |||
- | \\ | ||
- | |||
- | === options.inp === | ||
- | |||
- | Here the settings is same ([The files]), just the **ICUTT** parameter we have to change to value 1. Than the scan will be linear. Other values can stay same. | ||
- | |||
- | \\ | ||
- | |||
- | === scan.inp === | ||
- | |||
- | In the case of linear scan, the initial and final point should be changed maybe. But the **XMIN XMAX** or the **YMIN YMAX** will be same there. | ||
- | |||
- | |||
- | Than, you can run the **STM** code for linear scan simulation |