linear_stm
Differences
This shows you the differences between two versions of the page.
|
linear_stm [2009/11/30 11:32] vroz |
linear_stm [2011/02/18 13:13] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ==== The Linear STM ==== | ||
| - | The linear scanning gives us the current profile from the A point to the B point at constant height of the tip. To run this kind of scan we need to change some values at the "scan.inp" and "options.inp" files. | ||
| - | |||
| - | \\ | ||
| - | |||
| - | === options.inp === | ||
| - | |||
| - | Here the settings is same ([The files]), just the **ICUTT** parameter we have to change to value 1. Than the scan will be linear. Other values can stay same. | ||
| - | |||
| - | \\ | ||
| - | |||
| - | === scan.inp === | ||
| - | |||
| - | In the case of linear scan, the initial and final point should be changed maybe. But the **XMIN XMAX** or the **YMIN YMAX** will be same there. | ||
| - | |||
| - | \\ | ||
| - | |||
| - | ==== ==== | ||
| - | |||
| - | Than, you can run the **STM** code for linear scan simulation | ||
linear_stm.txt ยท Last modified: 2011/02/18 13:13 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
