linear_stm
This is an old revision of the document!
The Linear STM
The linear scanning gives us the current profile from the A point to the B point at constant height of the tip. To run this kind of scan we need to change some values at the “scan.inp” and “options.inp” files.
options.inp
Here the settings is same ([])
linear_stm.1259576612.txt.gz · Last modified: 2011/02/18 13:14 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
