linear_stm
This is an old revision of the document!
The Linear STM
The linear scanning gives us the current profile from the A point to the B point at constant height of the tip. To run this kind of scan we need to change some values at the “scan.inp” and “options.inp” files.
options.inp
Here the settings is same ([The files]), just the ICUTT parameter we have to change to value 1. Than the scan will be linear. Other values can stay same.
scan.inp
In the case of linear scan, the initial and final point should be changed maybe. But the XMIN XMAX or the YMIN YMAX will be same there.
Than, you can run the STM code for linear scan simulation
linear_stm.1259577137.txt.gz · Last modified: 2011/02/18 13:14 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
