This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
stmview [2010/07/22 15:43] prokop |
stmview [2010/07/23 13:43] prokop |
||
---|---|---|---|
Line 2: | Line 2: | ||
{{:stmview:stmview.tar.gz|}} | {{:stmview:stmview.tar.gz|}} | ||
+ | |||
+ | * The fork version which enable manual selection of minimum offset and scaling for rubbersheed. See the picture 4. This would enable to set | ||
+ | better positioning and roughness of the surface map in case when the default (automatic) positioning is not appropriate. Sometimes (if data in STM map has high values >1, the positioning of surface could be far from geometry) | ||
+ | {{:stmview:stmview-scale.tar.gz|}} | ||
==== Instalation ==== | ==== Instalation ==== | ||
Line 20: | Line 24: | ||
* Anytime you want to open a new file, you should edit the first two lines of "upravene-STM-out.genral" and "upravene-BAS.genral" as described above. | * Anytime you want to open a new file, you should edit the first two lines of "upravene-STM-out.genral" and "upravene-BAS.genral" as described above. | ||
* After that just Run the visual program MapAndBas-9.net and it should s view the geometry, surface and colorbar immediately. If not, there is probably a mistake in definitiion of paths. In this case try to checke Error message window and/or look on the imege window and run "Windows -> Open Visual Program Editor", there you can check what is wrong (shown yellow) | * After that just Run the visual program MapAndBas-9.net and it should s view the geometry, surface and colorbar immediately. If not, there is probably a mistake in definitiion of paths. In this case try to checke Error message window and/or look on the imege window and run "Windows -> Open Visual Program Editor", there you can check what is wrong (shown yellow) | ||
- | * If everythig goes well, check the "Control panle" | + | * If everythig goes well, check the "Control panel". There are several smaller controlpanels but the only importaint is the one shown on picture 1. Use picture 1 as a reference guide to this dialogs. |
+ | * To change the view go to //Options -> View Control//, There you want probably set "Mode:" to "Rotate" and/or "Set view" to "Front" | ||
=== Picture 1 - main Control Panel with help notes === | === Picture 1 - main Control Panel with help notes === |