Nanosurf Lab

stmview.tar.gz

• Correct instalation of OpenDX is expected (tested on SuSE 11.1)
• Extract STMview folder and try to open MapAndBas-9.net in OpenDX → Data Explorer → Run Visual Program. I would not probably work correctly yet.
• The “visual program” has hardwired absolute path to *.general files ( /home/prokop/Desktop/STMview ), you need to edit it. Look on the biggest “Control Panel” (see picture 1) and choose correct location of files “upravene-STM-out.genral” and “upravene-BAS.genral” in “Import name” dialog. Alternatively you can edit this dirrectly in text editor in MapAndBas-9.neb and MapAndBas-9.cfg
• Open “upravene-STM-out.genral” and “upravene-BAS.genral” in text editor and check if the first two lines matches the true location and size of files, if not edit it. Especially if there is relative address, change to absolute adress could help. Alternatively you can create correct new *.general files using “OpenDX → Data Explorer → Import Data → Grid or Scattered file”

 
file = /home/prokop/Desktop/STMview/answer.bas
points = 250

 
file = ./empty05.out
grid = 25 x 25

• Anytime you want to open a new file, you should edit the first two lines of “upravene-STM-out.genral” and “upravene-BAS.genral” as described above.
• After that just Run the visual program MapAndBas-9.net and it should s view the geometry, surface and colorbar immediately. If not, there is probably a mistake in definitiion of paths. In this case try to checke Error message window and/or look on the imege window and run “Windows → Open Visual Program Editor”, there you can check what is wrong (shown yellow)
• If everythig goes well, check the “Control panle”