stmview
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
stmview [2010/07/22 15:43] prokop |
stmview [2011/02/18 13:13] (current) |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| {{:stmview:stmview.tar.gz|}} | {{:stmview:stmview.tar.gz|}} | ||
| + | |||
| + | * {{:stmview:stmview-scale.tar.gz|}} - This fork version enable manual selection of minimum offset and scaling for rubbersheed. See the picture 4. This would enable to set better positioning and roughness of the surface map in case when the default (automatic) positioning is not appropriate. Sometimes (if data in STM map has high values >1, the positioning of surface could be far from geometry) | ||
| + | |||
| ==== Instalation ==== | ==== Instalation ==== | ||
| Line 20: | Line 23: | ||
| * Anytime you want to open a new file, you should edit the first two lines of "upravene-STM-out.genral" and "upravene-BAS.genral" as described above. | * Anytime you want to open a new file, you should edit the first two lines of "upravene-STM-out.genral" and "upravene-BAS.genral" as described above. | ||
| * After that just Run the visual program MapAndBas-9.net and it should s view the geometry, surface and colorbar immediately. If not, there is probably a mistake in definitiion of paths. In this case try to checke Error message window and/or look on the imege window and run "Windows -> Open Visual Program Editor", there you can check what is wrong (shown yellow) | * After that just Run the visual program MapAndBas-9.net and it should s view the geometry, surface and colorbar immediately. If not, there is probably a mistake in definitiion of paths. In this case try to checke Error message window and/or look on the imege window and run "Windows -> Open Visual Program Editor", there you can check what is wrong (shown yellow) | ||
| - | * If everythig goes well, check the "Control panle" | + | * If everythig goes well, check the "Control panel". There are several smaller controlpanels but the only importaint is the one shown on picture 1. Use picture 1 as a reference guide to this dialogs. |
| + | * To change the view go to //Options -> View Control//, There you want probably set "Mode:" to "Rotate" and/or "Set view" to "Front" | ||
| === Picture 1 - main Control Panel with help notes === | === Picture 1 - main Control Panel with help notes === | ||
| Line 34: | Line 38: | ||
| {{:stmview:screenshot-1.png| Picture 3 - View from front (go to " Options -> View Control -> Set View -> Front ") with hi opacity (0.5)}} | {{:stmview:screenshot-1.png| Picture 3 - View from front (go to " Options -> View Control -> Set View -> Front ") with hi opacity (0.5)}} | ||
| + | === Picture 4 - Example of usage STMview-scale fork === | ||
| + | {{:stmview:screenshot3-.png| Picture 4 - Example of usage STMview-scale fork }} | ||
stmview.1279806203.txt.gz · Last modified: 2011/02/18 13:14 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
